0 ITEM(S) IN YOUR CART / TOTAL:$0
FMIC's & Piping
Amarid fiber Intake Manifold spacer S40 4cyl
Email a friend
Review this item
select name from list
other, add new name below
or add name:
*We'll ask for shipping info at checkout
Add to Wish List
Intake spacers help to isolate the intake manifold from the conducted heat of the engine block. Our spacer is made from heat resistant Aramid Fibers with a nitrile binder. This is a self sealing spacer/gasket with no additional gasket(s) needed. Snabb's exclusive spacer not only blocks conductive heat from the aluminm engine block but is resistant to heat, water, aliphatic hydrocarbons, oil and gasoline. It also has a very high tensile strength of 1500 psi. Specs aside, does it work? YES! Average decrease in Intake air temperature is 15 degrees f but we've seen as high as 25 degree f reduction in IAT's.
Our spacers have a
thermal conductivity of
(the thermal conductivity of aluminum is 250 w/k*m)
which results in significantly less heat being directly conducted to the intake manifold and therefore lowers the intake air temperature, in turn creating more power.
Made from 1/8" thick -low thermal conductivity- Aramid fiber composite
Uses stock intake manifold bolts
Does not require the use of additional intake manifold gaskets
Please note that it is imperative that the spacers be torqued down in stages to no more than 15 foot pounds. The spacers may crack or deform if over torqued, it is recommended that they be installed by an ASE certified technician.
960 Turbo Big Bore Throttle Body Plate
NA Throttle Body with 960 Plate
AEM Dryflow Airfilter 2.75" x 5"
K&N V70R S60R air filter
AEM 3.5" Dryflow airfilter
3.0L T6 High flow intake kit with MAF
Browse Similar Items
2027 Slaterville Road #4
Subscribe to our Newsletter
Terms and Conditions
Become an Affiliate